GUIDE 02

Kerf and rotation change what actually fits.

A saw line has width. A rotated part may fit unless grain or finish prevents it.

Kerf in millimetres

TRAZA reserves the entered width between heuristic partitions. It does not add kerf outside a sheet edge. Confirm the value for your tool and process.

Rotation per part

Allowing 90° permits width and height to swap. Disable it when grain, pattern, face, or structural direction matters.

Before cutting

The report is indicative, not a certified cutting sequence. Check clamping, edges, tolerances, grain, safety, and physical measurements.

Test the decision with your dimensions.Back to the comparator →